Input shaft is 3 4 36 splined shaft.
Mustang ii power rack and pinion pressure port.
Begin the installation by assembling the proper adapters into the pump and rack pinion.
The pressure port is m14 1 5 o ring.
Low pressure from rack to reservoir high pressure from pump to rack rack and pinion specifications.
The flanged side of the bushing will be towards the crossmember.
Care must be taken that the hoses are hooked up correctly since the braded hose adapters supplied with most hook up.
Use figures below to determine the pressure port for your part number.
Order rack pinion complete unit for your 1978 ford mustang ii and pick it up in store make your purchase find a store near you and get directions.
Care must be taken that the hoses are hooked up correctly since the braded hose adapters supplied with most hook up kits convert both ports to a 6 hose size.
The high pressure fitting is the m14x1 5 thread port which is toward the front of the rack and the return fitting is m16x1 5 thread port that is at the rear closest to the pinion input shaft.
Rack and pinion steering on the other hand is generally.
If the hoses are incorrectly installed the internal pressure will blow out the.
The mounting bolts are 5 8 diameter.
This video explains plainly which port on the mustang fox body and sn 95 rack and pinions are the high pressure port and which is the low pressure return port.
Low pressure from the rack into the reservoir.
Because ports are the same thread size the pressure and return hoses can be reversed causing violent self steering and damage to the rack.
Work out your hose routing and decide where to use each hose end extra hose ends and hose are available.
The return port is m16 1 5 o ring.
Your order may be eligible for ship to home and shipping is free on all online orders of 35 00.
The high pressure fitting is the m14x1 5 thread port which is toward the front of the rack and the return fitting is m16x1 5 thread port that is at the rear closest to the pinion input shaft.
Some installations may need to use the rack and pinion spacers.
The mounting bolts are spaced 15 1 2 apart.
The pressure port in the rack is the 1 2 20 port.
The original rack pinion may have a removable check valve in the.
Ford rack pinion units with same size pressure and return ports.
Ends as the mustang ii rack.
Check here for special coupons and promotions.
Most steering gear applications would run between 1 100 1 300 psi with heavy vehicle high demand applications on up to 1 550 1 600 psi.
The kit comes with 90o hose ends.
Using the 2 mounting bolts and mounting bushings bolt the rack and pinion onto its mount.
Pressure fitting is 6an.
